Please Note : All prices are for UK customers only - if you are looking at our site from outside the UK please contact us on +44 1462 457186.
Every single one of our products is formulated and manufactured to perform to the highest standard, and will give you the consistent results you require every time you brew. They are also backed by the same commitment to customer service and quality which you would expect from the Murphy & Son name.
We supply these products to pub breweries, micro breweries, regional breweries, family brewers and multinationals in the UK and around the world, as well as multinational breweries both for the UK and export. In fact, there is no other company offering the range of products and technical expertise provided by Murphy & Son which is probably why we have built up an enviable client list of over 800 companies of all sizes.
To find out more, browse around our Product ranges now and order today. It’s easy to order online straight away or you can call our order line on 0115 978 0111. If you have any technical questions before ordering or would like advice, please call us on 0115 978 5494.
This product is no longer in stock
*****PLEASE BE AWARE THIS PRODUCT HAS A 10 DAY LEAD TIME**
Adhol No. 10 is an additive used for blending with Caustic Soda solutions. It is specifically designed to boost the
detergency of not readily saponified or hydrolysed soils by supplying a source of active oxygen.
Adhol No. 10 is designed primarily for applications in Breweries, Beverage, Dairies and Food Processing plants; it
is also suitable for use in other high care industries.
In use concentrations of Adhol No. 10 are application dependent and should be established during trials. For
occasional deep cleans, concentrations will typically be between one third to one half of the caustic v/v
concentration. If Adhol No. 10 is used for routine cleaning lower concentrations should be used, typically
between one tenth to one quarter of the caustic v/v concentration. Maximum concentrations will typically be
Cleaning temperatures should be optimised during trials, but for maximum benefit must be between 70 – 80°C.
Temperatures should not be allowed to exceed 85 – 90°C, at this level the evolution of oxygen will be very rapid
and the detergency benefit will be lost.
It is important to note that long term poor control of concentration through over dosing, poor control of
temperature, or local hot spots could result in discolouration of Stainless Steel.
Adhol No. 10 is not designed for direct food contact.
The following are typical example applications, users should refer to Cleaning Instruction Cards for specific
guidance. Other applications should be discussed with your Holchem Consultant.
General Use. The addition of Adhol No. 10 to caustic causes the evolution of oxygen bubbles, these have a scouring
and oxidising effect on soils.
Although Adhol No. 10 can be added at any point in a CIP or boil-out clean, it is better to run for approximately
one third of the CIP cycle with caustic before adding Adhol No. 10. A second additive can then be introduced two
thirds of the way through the clean. Using this split dosing technique will reduce the potential for discolouration
of Stainless Steel surfaces. Alternatively the dose should be delivered slowly over the entire cleaning cycle.
Because Adhol No. 10 evolves oxygen bubbles it is essential to ensure that the circulation loop is vented, or, if
fitted, pressure relief valves are operating.
In some applications excess foam may be generated, in these circumstances Adhol No. 10 can be used in
conjunction with Defoam.
· Adjustable rate of addition to meet requirements.
· Cost effective.
· Boosts performance of caustic solutions.
These trace elements enable the birds to maintain an excellent...